I'm not sure is PICKit capable of running on 30MHz. If breakpoins are set by themself....
Debugger is always problematic cause of cabling and connector. Little disturbance and debugger halts. Did you tried running without debugger?
Without debugger PIC must reset (if your code does not run in loop) and RCON will say why.
Try also running on lowe freq, eg 16MHz.
In my case one of big problems was Vcap. It must be 10uF 16V tantalum or ceramic. Hi quality one!
Debugger is always problematic cause of cabling and connector. Little disturbance and debugger halts. Did you tried running without debugger?
Without debugger PIC must reset (if your code does not run in loop) and RCON will say why.
Try also running on lowe freq, eg 16MHz.
In my case one of big problems was Vcap. It must be 10uF 16V tantalum or ceramic. Hi quality one!